End mills can be used for face milling. However, because the main declination angle is 90°, the force on the tool is mainly radial force in addition to the main cutting force.
It is easy to cause deflection and deformation of the tool bar, and it is also easy to cause vibration, which affects the processing efficiency.
Therefore, except for workpieces with thin bottoms requiring small axial forces or occasional face milling to reduce tool inventory
Outside of these special reasons, end mills are not recommended for machining flat surfaces without steps.

This article was written by: admin

发表评论 取消回复

邮箱地址不会被公开。 必填项已用*标注

Let us know what you have to say:

Your Name *

Your Email *

在此浏览器中保存我的姓名、电子邮件和站点地址。